Friday, January 24, 2020

A Solution To The Failed Paint Tube Caps

It has been a constant battle for me, trying to keep older tubes of paint from being unusable. Once the caps crap up, and don't fit anymore, the tubes start to end-dry, and then harden. Especially the alkyds, which cure when exposed to air. I have wasted too many hours of what is left of my life digging out caps, cleaning off threads on tubes, and digging out tubes to get to the wet usable paint, only to have to do it again next day. For oils this is not as big a deal. Oil is cleanable, and usually takes so long to cure only a skin forms on the tube that does not penetrate into the tube. Hardly any need for caps in oils as a result. Acrylics and alkyds are a different story.

So, I was looking at bolt end covers after looking at a wire shelf end cap in my hardware cabinet, and a light bulb went off. It appears that the vinyl bold caps come in many sizes and depths. My tubes are  mostly 3/8th inch (or 10mm) and there is an end cap that size. They come in a variety of depths as well, as they are designed to protect bolt ends from injuring others, or from paint when a bolted product is painted. Protects the threads.

I also found a 3/8 inch silicone end cap in the auto world, as vacuum line caps, so I ordered some of those as well. I am currently using both and will see which is better. I suspect the silicone will work better, as it it stretchier and more pliable, making a better seal. If one buys them in bulk, they are cheap. The green ones in the photos were 50 for 10$. If you get the 3/8 x 1/2" length vinyl caps from the hardware store, they are over 50c apiece. I suspect the silicone will be more resistant to paint adhesion as well, since I use silicone pans to mix gesso, and just squish the pan when the remnant is dry, and it just falls out or easily peels out. Nothing sticks to it....

Stay tuned, and I will see how they do.











1 comment:

  1. Great idea. Wish there was a type of aftermarket cap that would screw on and used a type of flip cap or push-pull cap to close the tube.

    ReplyDelete